Table of Contents
Advertisement
10 Convergence Adjustment
The convergence adjustment is set separately for each
50/100Hz/ 60/100Hz input (NTSC, PAL/ SECAM). The
following explanation uses the PAL mode as an example, since
the same procedure applies to the convergence adjustment for
NTSC mode.
When replacing the following Parts.
IC7301 (EEP-ROM in A-Board)L551 (Pincushion Coil)High
Voltage
Producing
Parts
convergence)
Create an Adjustment Sheet by tracing the following
specifications in their actual size on transparent film or tracing
paper.Then adjust the convergence.
When replacing one of the CRT´s.
10.1. Convergence Adjustment Sheet
Other
Parts
(If
change
Adjust the convergence for each of the 50/100Hz and
60/120Hz inputs so that they are aligned with the other colours.
Helpful Hint
All positions which have been adjusted are recorded within P-2
for NTSC data and P-3 for PAL data of the memory.This data
can be copied to P-4 memory area, allowing you to perform the
adjustment of P-2 (NTSC) and P-3 (PAL).To perform these
the
adjustments, push the SEARCH button on the remote control,
and manipulate the position [
button as instructed by the On Screen Display in Fine
Convergence adjustment.
All of the Convergence Control Charts have been listed for the
remote control buttons after the Convergence Adjustment
Procedure Please refer to these. (Page 29)
31
TX-47P800HQ / TX-47P800HZ
] and [
] button and the "N"
Advertisement
Table of Contents
