Table of Contents
Advertisement
TX-47P800HQ / TX-47P800HZ
8.3.
PAL Progressive mode (50p)
8.3.1.
Preparation
1. Receive PAL monoscope pattern.
2. Copy the Data of PAL 100Hz mode (100i) to PAL
Progressive mode (50p)
3. Set scan mode to progressive.
4. Set the Aspect Menu to 16:9.
5. Set the Picture Menu to NORMAL.
6. Set the TV to Service Mode 1.
7. Set the Data of Service Mode 1 as follow
H-Parallel
IVBL C
Top-Corner
8. Push [ 0 ] button so that set the Data of Coarse/Fine
Convergence to Zero Correction.
9. Push [ HELP ] button so that projecting Green only.
8.3.2.
V-Amp, V-Linear and V-Pos
Adjustment
1. Adjust Vertical amplitude for 2.3 ± 0.1 division of a scale by
V-Amp control.
2. Confirm Vertical Linear as to the balance of circle, if need
adjust V-Linear control.
3. Confirm Vertical Center, if it is not correct, adjust
Monoscope pattern for center of the screen by V-Pos
control.
8
Bottom-Corner
95
V-S-Correct
177
C-Correct
8.4.
NTSC Progressive mode (60p)
8.4.1.
Preparation
1. Receive NTSC monoscope pattern.
2. Set scan mode to Progressive.
3. Set the Aspect Menu to 16:9.
4. Set the Picture Menu to NORMAL.
5. Set the TV to Service Mode 1.
6. Set the Data of Service Mode 1 as follow
H-Parallel
IVBL C
Top-Corner
177
65
7. Push [ 0 ] button so that set the Data of Coarse/Fine
7
Convergence to Zero Correction.
8. Push [ HELP ] button so that projecting Green only.
8.4.2.
H-Pos and H-Amp Adjustment
1. Adjust Monoscope pattern for center of the screen by H-
Pos control.
2. Adjust Horizontal amplitude for 2.3 ± 0.1 division of a scale
by H-Amp control.
24
8
Bottom-Corner
167
95
V-S-Correct
176
C-Correct
65
7
Advertisement
Table of Contents
