Daikin FTX20KV1B Operation Manual page 25

Care and Cleaning
FTX50KV1B / FTX60KV1B
„ Titanium apatite photocatalytic air-purifying filter
1.
Open the front panel and
pull out the air filters.
2.
Take off the titanium apatite
photocatalytic air-purifying
filters.
• Hold the recessed parts of the frame and unhook
the 4 claws.
Claw Claw
3.
Clean or replace the
titanium apatite
photocatalytic air-purifying
filters.
[Cleaning]
3-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15 minutes if very dirty.
• Do not remove the filter from the frame when
washing with water.
3-2 After washing, shake off remaining
water and let them dry in the shade.
• Do not wring out the filter to remove water from it.
[Replacement]
Remove the filter from the filter
Page 23
frame and prepare a new one.
• Do not throw away the filter frame. Reuse the filter
frame when replacing the titanium apatite
photocatalytic air-purifying filter.
• Dispose of the old filter as non-flammable waste.
4.
Insert the titanium apatite
photocatalytic air-purifying
filters as they were.
• When attaching the filter, check that the filter is
properly set in the tabs.
5.
Reattach the filters.
6.
Close the front panel
slowly.
NOTE
• Operation with dirty filters:
− cannot deodorize the air,
− cannot clean the air,
− results in poor heating or cooling,
− may cause odor.
• Dispose of old filters as non-flammable waste.
• To order a titanium apatite photocatalytic air-purifying filter, contact
the dealer where you bought the air conditioner.
Item
Part No.
Page 23
Titanium apatite photocatalytic
air-purifying filter 1 set
KAF970A46
Care
Page 23
24