Panasonic WV-CP630 Installation Manual page 18

4
Secure the camera mount
bracket (option) to an installation
position, and mount the camera
on the camera mount bracket.
Important:
• If the total weight of the camera and lens
exceeds 1 kg, use a housing to take mea-
sures against camera drop.
• Prepare mounting screws according to the
material of the area where the camera
mount bracket (option) is to be installed.
The installation method may be different
depending on the material of the area
where the bracket is to be installed.
• When installing on steel:
Fix with bolts and nuts (M6 or M8).
• When installing on concrete:
Fix with anchor bolts or AY plug bolts
(M6 or M8).
Recommended tightening torque (M6):
5.0 N·m
Recommended tightening torque (M8):
6.2 N·m
• The mounting conditions of the camera mount bracket are described as follows:
Installation
position
On ceiling
On wall
5 Secure the safety wire to the foundation part of the construction or a part
with adequate strength (minimum pull-out strength 196 N).
Prepare the fixing screw according to the material of the area where the safety wire is to be fixed.
For mounting on ceiling, use the safety wire, washer (accessory) and spring washer (accessory).
Important:
• The safety wire shall be adjusted to remove slack.
• Be sure to install the safety wire to prevent a fall of the camera resulting in injury or accidents in
case the camera comes off.
• To prevent the mounting strength from becoming lower, do not use wooden screws to secure
the safety wire.
18
Recommended
screw
M6 or M8
M8
<Installation sample on a ceiling>
Screws (locally
procured)
Screw quantity
4 pcs.
4 pcs.
Camera mount
bracket (option)
Screws (locally
procured)
Minimum pull-out
strength (per 1 pc.)
562 N
921 N