Miele KFN 14943 SD Operating And Installation Instructions page 59

^ Remove cap l from the bearing
bush in the door and refit on the
opposite side.
Refitting the lower door:
^ Pull hinge pin a with disc b and foot
c upwards to remove them.
^ Remove cap d.
^ Undo screws e and take hinge plate
f off.
^ Unscrew bearing g from hinge plate
f, rotate it by 180° and refit into the
Changing the door hinging
hole on the opposite side of the hinge
plate.
^ Place cap d in the other hole.
^ Remove cover h.
^ Undo screw i and screw it into the
outermost hole on the other side.
^ Rotate cover h by 180° and click it
into the holes on the other side.
^ Screw hinge plate f into position on
the opposite side using the two outer
long slots only. Do not use the
middle screw because you will not
be able to align the door over the
outer long slots later on.
^ Important! Screw foot c into hinge
pin a as far as it will go.
^ Reinsert hinge pin a with disc b and
foot c. Important! The lug on the
hinge pin must face backwards.
^ Place the lower door onto hinge pin
a.
^ Close the lower appliance door.
59