Table of Contents
Advertisement
4.3.4 Properties
Select this sub-selection, the screen will show the properties of the file.
4.3.5 Cancel
Select this point to cancel any editing operations.
Advice:
The "Edit" button is only effective if the HDD is formated with the FAT32 file system.
5. Annex
5.1 FAQ
Before you contact our service department, please read the following guide.
Symptom
No power
Power is on, but the unit does not
work properly
No picture on the display/ TV/ PC
No volume
Playing pictures glimmering or
having a bad quality
The remote control does not work
5.2 Copyright and trademark information
Copyrights
Possible reasons
Power cable not plugged in
Restart the media player
Media player not connected
properly
Video output does not comply
with the display equipment
Display input is not set to receive
the player's signal
Volume is set to 0 (TV or media
player)
Audio cable not connected
properly
Reset and choose the correct TV
format such as NTSC or PAL
Bad picture quality provided
Battery status low
Battery not installed properly
Remote control does not point at
the remote sensor
Too long distance or too big
angle
Remote control route malfunction
Resolutions
Check if the DC power cable is
plugged in correctly
Disconnect the media player from
power, wait a few seconds and
restart the media player
Connect the media player as
described in this manual
Press the „HDMI/AV" key on the
remote control
Select a proper video input
format, usually it is video or AV
Adjust the volume (Volume +)
Connect the audio cable correctly
Restart the media player and
select the correct TV or display
format
Take pictures with better quality
Install new batteries, ensure
using the same size of batteries:
AAA, 1,5V
Install batteries correctly
Point the remote control at the
remote sensor
Keep a distance within 6m from
the front panel remote sensor;
lower angle to the sensor
Remove obstacles between the
player and the remote control
Advertisement
Table of Contents
