MTX Thunderform Installation Manual page 7

19.
Reinstall threshold trim. Locate and align holes in vehicle with pins
on trim; it will snap into place easily.
20. If enclosure is unloaded, install the enclosure into vehicle as shown
below with screws provided. If loaded, remove woofer from enclosure
then install the enclosure into vehicle.
#lO x 1" Phillips
Truss Head
Ledge of
vehicle
21. Place gasket provided around woofer hole cutout. Connect
black
wire to the negative side of woofer and red wire to the positive side.
Using screws provided install woofer, making sure not to over-tighten
screws to avoid stripping.
22. Install grill, insert pegs provided into holes on the back of grill using
a 7/W nut driver to push pegs into the holes. Align the pegs on grill with
the receptacles on enclosure and snap into place.
23. Re-install trim panel in rear of vehicle on the driver side.
For technical assistance call I-800~CALL MTX.
These instructions are guidelines only and in no way are intended to
replace a professional installation. As always before screwing or drilling
6