Speaker Wires - MTX Thunderform Installation Manual

drill from inside of vehicle using a short bit.
8. Route IOga red power wire through grommet into the engine
compartment.
9. Route 1Oga red power wire through engine compartment safely away
from any moving or hot parts that could damage the wire.
10.
Cut IOga red power wire to length, connect the supplied fuse
holder from the wire kit to the end of the wire.
11.
Remove 15amp fuse from MTX fuse holder. Connect furnished
ring terminal to positive side of battery. Remove 5/16" bolt from factory
battery terminal. Pass bolt through factory battery terminal, then ring
terminal, and into the other side of factory battery terminal and retighten
bolt.
12. Ground amplifier to chassis of vehicle; connect the terminal provided
to the 10ga black wire from furnished wiring harness. A good ground is
as important as the power connection. The ground should be as short as
possible and the contact point should be free of paint and debris.
SPEAKER WIRES
13. Tap into rear speaker wires and route under carpet to the rear
seat, over to pre-amp on enclosure. Speaker wires can be located by
removing rear speaker grills in the "B" pillar directly behind front seats.
(see drawing) Colors are right channel; dark blue (positive) light blue
(negative), and left channel; brown (positive), yellow (negative).
3