Table of Contents
Advertisement
BLOWER
Note: If any of the original wire must be replaced, it must be
replaced with type TEW minimum 16GA copper wire rated at 105°C
HEAT DEFLECTIVE HOOD
INSTALLATION
The factory supplied heat deflective hoods
must be installed inside the fireplace opening
on both sides for the safe operation of the unit
as shown in Figure 18.
1. Remove protective covering from
hoods.
2. Position deflective hood into opening
on one side of the firebox and secure
to the top of the opening using screws
provided.
3. Secure the ends of the hood to the firebox
using two screws (provided) for each
side.
4. Repeat steps 2 and 3 to install hood on
the opposite side of the firebox.
CAUTION: Do not clean hood
with abrasive cleanser. Use only
regular household cleaners and
a smooth cloth.
126703-01A
INSTALLATION
VARIABLE
ELECTRICAL RATING:
SPEED
120v, 60Hz, 0.9A
CONTROL
Figure 17 - Optional Blower Wiring Diagram
www.SuperiorFireplaces.US.com
Continued
BLK
WHT
RECEPTACLE
GRN
GND
Front Hood
(Typical Each Side)
Corner
Post
2 Screws Each
End of Hood
Figure 18 - Typical Hood Installation
FIELD WIRE
BLK
INCOMING
120V AC
WHT
(FUSE BOX
BREAKER)
GRN
CONNECTORS
(NOT SUPPLIED)
3 Screws
(Top)
(Both Sides)
OR
15
Advertisement
Table of Contents
