The Ethernet Tab - SonicWALL TELE3 SP Administrator's Manual

• Service - HTTP
• Source - WAN
• Destination - LAN 192.168.1.10 - 192.168.1.12
• Apply this rule - always
9. Click Update and restart the SonicWALL.
The server configurations take effect after the SonicWALL restarts and the configuration is
updated. Requests for http://208.1.2.4 are answered by the server at 192.168.1.10. Requests
for http://208.1.2.5 are answered by the server at 192.168.1.11, and requests for http://
208.1.2.6 are answered by the server at 192.168.1.12. From the LAN, the servers can only be
accessed using the private IP addresses (192.168.1.x), not the public IP addresses or domain
names. For example, from the LAN, you must use URLs like http://1921.168.1.10 to reach the
web servers. An IP address, such as 192.168.1.10, on the LAN cannot be used in both public
LAN server configurations and in public LAN server One-to-One NAT configurations.

The Ethernet Tab

The Ethernet tab allows the management of Ethernet settings using the SonicWALL
Management interface. The tab has the following settings:
• WAN Link Settings
• LAN Link Settings
• Bandwidth Management
The default selection for all of the link settings is Auto Negotiate because the Ethernet links
automatically negotiate the speed and duplex mode of the Ethernet connection. The other
choice, Force, with lists for speed and duplex, should be used only if your Ethernet card also
forces these settings. You must force from both sides of your connection to enable this setting.
Advanced Features Page 95