Reflector Dome - Napoleon PTH-103-3G Installation, Operation And Maintenance Instructions

STEP 7. Attach Reflector
 Combine three pieces reflector together
 Tighten up with three 5/32" screws.
 Put the reflector plate on reflector then tight up with
three 1/4" screw by upward.
STEP 8: Attach The Post
.

Screw the 1/4"x2 3/4" threaded ends stud into
emitter top.

Attach the reflector dome cap and nut on the
emitter top. It screws on threaded stud screwed
onto emitter top.

Insert gas hose through post.

Attach the post on to heater head with four of
3/16" truss head screw.
ASSEMBLY INSTRUCTION
Page 7
STEP 7
STEP 8