General Operation - Harbor Freight Tools PacificHydroStar Owner's Manual & Safety Instructions

Operation
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
After reading these instructions, consider the following points before starting the pump:
1. Verify that the pump rests on the floor.
2. Verify that the delivery pipe is properly connected.
3. Verify that the electrical connection is 120VAC, 60 Hz.
4. Verify that the electrical socket is in good condition.

General Operation

1. BEFORE EVERY USE, make sure Impeller can
move freely by inserting slotted screwdriver into
center hole on Fan Cover and turning fan.
Figure G: Fan Cover
Page 8 For technical questions, please call 1-888-866-5797.
5. Verify that water and moisture cannot
get near the power supply socket.
6. Verify that the pump is installed so
as to prevent running dry.
2. Dry hands, then plug Power Cord into
a 120V GFCI protected outlet.
CAUTION: Do not run the Pump Dry! Unplug the
Pump IMMEDIATELY if no water comes out the outlet.
3. Inspect Pump and plumbing for leaks. If
any leaks are present, dry hands, then
unplug Pump and repair leaks.
4. When finished using Pump, dry hands,
unplug from electrical outlet, then follow
Maintenance instructions on page 10.
Item 62508