Sub-Zero UC-15I Installation & Operation Manual page 14

S U B - Z E R O
I N S TA L L AT I O N
D O O R P A N E L I N S T A L L AT I O N
You should be sure of the door panel size and
placement before proceeding with the installa-
tion. If you have questions, contact your
Sub-Zero dealer or cabinet supplier. Instruc-
P A N E L
tions regarding sizing of the door panel are
D E S I G N
provided in the Sub-Zero design guide.
For door handle hardware, a D-style pull
Additional panel
centered on the edge opposite the door hinge
design information
side is recommended. Screw heads may have
can be found in
the Sub-Zero to be countersunk to ensure that the hardware
design guide.
does not interfere with the panel fitting flush
Check our website
with the unit door.
at subzero.com.
D O O R P A N E L D I M E N S I O N S
Door Panel Width –
Door Panel Height –
4" (102) toe space
Door Panel Thickness
Door Panel Weight
Dimensions may vary + _
14
I C E M AC H I N E I N S TA L L AT I O N
1
/ " (3) reveal
8
1
/ " (3) reveal
8
15 lbs (6.8 kg) max
1
/ " (3).
8
Flush with Top and Side
of Panel
Template position
Remove the handle side bracket attached to
the front of the door and set aside.
Place the door panel lying face down on a
protected surface to ensure the front is not
scratched or damaged.
Position the template provided flush with the
upper edge of the door. Be sure you are
following the exact location for the RH or LH
door position. Refer to the illustration below.
IMPORTANT NOTE: Remember you are
viewing the door panel from the back side in
the illustration. The overall size of the panel
shown is the minimum size necessary to cover
the door of the unit. The exact measurements
of your door panel may vary depending on the
particular installation you are following.
15" (381)
Once you have located the proper position for
the hardware, mark the holes, remove
3
30 / " (772)
8
template, and drill pilot holes for mounting of
the hardware. We recommend starting the first
5
/ " (16) min
8
few holes, positioning the hardware, drilling
remaining pilot holes, and securing the
mounting brackets with the #8 x
Refer to the illustrations below.
Right-hand door panel
1
/ " screws.
2
Left-hand door panel