Lincoln Electric IM869-D Operator's Manual page 15

B-3
ENGINE CONTROLS
IGNITION SWITCH
When placed in the "ON" position, this switch ener-
gizes the fuel solenoid. When placed in the "OFF" posi-
tion, the flow of fuel to the injection pump is stopped to
shut down the engine.
"IDLER" SWITCH
The idler switch has two positions, "HIGH" and
"AUTO".
When in "HIGH" ( ) position, the engine will run
continuously at high idle.
When in "AUTO" ( /
operates as follows:
a. Welding
When the electrode touches the work, the welding
arc is initiated and the engine accelerates to full
speed.
After welding ceases (and no auxiliary power is
being drawn), the engine will return to low idle after
approximately 10 to 14 seconds.
b. Auxiliary Power
With the engine running at low idle and auxiliary
power for lights or tools is drawn (approximately
100-150 watts or greater) from the receptacles, the
engine will accelerate to high speed. If no power is
being drawn from the receptacles ( and not weld-
ing) for 10-14 seconds, the idler reduces the engine
speed to low idle.
ENGINE TEMPERATURE GAUGE
Displays the coolant temperature in the engine block.
ENGINE OIL PRESSURE GAUGE
Displays the oil pressure to the engine. When the
engine starts running, watch for the oil pressure to
build up. If no pressure shows within 30 seconds, stop
the engine and consult the engine instruction manual.
BATTERY CHARGING AMMETER
Displays the current going from the charging alternator
into the batteries. It is normal for charging current to be
high (above 15 amps) after starting or when the batter-
ies are ʻlowʼ on charge.
ENGINE HOUR METER
The engine hour meter records the total running time
on the engine in hours. It can be used to keep a record
of maintenance on the engine and or welder.
OPERATION
) idle position, the idler
SAE-400
ENGINE PROTECTION SYSTEM
The engine protection system shuts down the engine
under high coolant temperature or low engine oil pres-
sure conditions by allowing the fuel solenoid valve to
close.
WELDER CONTROLS
POLARITY SWITCH
Turn the Arc Polarity switch to electrode positive or
electrode negative as required for each particular
application.
CONTROL OF WELDING CURRENT
Purpose of Controls
The continuous "Current Control" is the main current
adjuster. The "Job Selector" is both a fine current
adjuster and the continuous Open Circuit Voltage
adjuster. Open Circuit Voltage (OCV) controls the arc
characteristics.
"Job Selector"
The "Job Selector" dial is divided into four colored sec-
tions providing OCV ranges as follows:
Color Title
White Large Electrodes
Black Normal Welding
Red Overhead & Vertical
Grey Special Applications
The "Job Selector" is usually set in the black range
because it provides a soft "Buttering " arc desired for
most welding. Some operators prefer to set the "Job
Selector" in the red range for a snappy "Digging" arc
when welding vertical up or overhead.
"Current Control"
CAUTION
Do not adjust the "Current Control" while welding
because this can damage the control.
------------------------------------------------------------------------
The "Current Control" dial is calibrated in amperes on
three separate colored dials corresponding to the
white, black and red ranges of the "Job Selector" dial.
For example: when the "Job Selector" is set on the
black range, the approximate welding current is indi-
cated on the black scale of the "Current Control" dial.
B-3
OCV Range
High OCV
Medium OCV
Low OCV
Extra-Low OCV