Tecsun PL-600 Owner's Manual page 5

SYSTEM SET CODES
continued
CHANGING SYSTEM SET CODES
To enter a system code of your choice,
use the procedure below.
1. Turn off the radio.
2. Press/release the SYSTEM SET button
(18). Note that '- - ' (48) appears in the
upper right corner of the display and
the clock digits disappear.
3. Within 5 seconds, enter the desired
numeric code with the numeric key pad,
then immediately press/release the
button labeled SYSTEM SET. The code
ICON (49) will briefly appear in the
lower right corner of the display.
DEFAULT FACTORY SYSTEM SET
CODES
When shipped from the factory, the radio's
System Set Code Table is set up as
follows. Changes can be made via the
procedure shown in the section titled
CHANGING SYSTEM SET CODES.
8 ADDITIONAL PL-600 CONTROLS
USING THE LIGHT
A quick, short press/release of the
LIGHT/SNOOZE button (7), located on
the front of the radio's upper right corner,
will turn on the display light, shining from
the left side of the display, for about 5
seconds. A longer press/release of the
button (about 3 seconds) will cause it to
stay on indefinitely (note that this will
decrease battery life). Turn off the light
with a quick short press of the button.
Ten pages with 50 memories each.
●
Code 08.
9 KHz AM (MW) tuning rate. Code 09.
●
Rechargeable batteries to be used.
●
Code 28.
● 87-108 MHz FM frequency coverage.
Code 87.
LW band Deactivate. Code 55.
●
MONITORING THE CURRENT STATUS
OF SET CODES AND OTHER
SETTINGS
Performing a three second press of the
SYSTEM SET button, with the PL-600
turned off, allows monitoring of key set
codes and other settings. This information
quickly flashes in the display in the
following order.
1. 9 or 10 kilohertz setting
2. Rechargeable battery milliamp-hour
setting
3. FM tuning range setting
4. Timer A's radio frequency
5. Timer B's radio frequency
USING THE ANTENNA GAIN SWITCH
The Antenna Gain switch (23) has three
positions, DX, NORMAL and LOCAL. This
switch should normally be in the DX
position, providing maximum receiving
performance. If the FM or Shortwave
station that you are listening to is s
overwhelmingly powerful and causes
distortion, try the NORMAL or LOCAL
position. This switch is not used for AM
station.
DIAGRAMS
continued
RADIO OFF DISPLAY
33. Battery Symbol
34. Clock Digits
35. Timer Digits
Timer A
Timer B
Ni-MH
Battery
A B
36. Timer Activation Symbol
37. Ni-MH Battery Symbol
MEMORY DISPLAY
Refers only to the display's upper right corner.
PAGE PRESET
45. Delete Indicator
46. Memory Display
SYSTEM SET CODE DISPLAY
48
49
kHz
PL-600 OWNER'S MANUAL
RADIO ON DISPLAY
40. Clock
33. Battery Symbol
Digits
38. Antenna Symbol
39. 1-5 Scale
Sleep Timer Symbol
Timer A
SL EEP
Timer B
0 1 2 3 4 5
Ni-MH
Battery
SLOW
kHz A B
FM MW LW Shortwave SSB Bandwidth N
36.
Timer
42. SSB
44. FM,
Activation
MW, LW,
Symbol
Shortwave
43. Frequency Digits
Indicators 41. Bandwidth
SHORTWAVE METER
BAND DISPLAY
Refers only to the display's upper right corner.
mb
47. Shortwave Meter Band Display