Mounting To Solid/Hollow Surface - Bunker Hill Security 62367 Owner's Manual

Mounting to Solid Surface
1. Using a drill bit slightly smaller
than the Screws, drill pilot holes
into the marked locations.
2. Position Mounting Bracket so that
mounting holes align with pilot holes.
3. Drive Screws through mounting
holes in Base and into pilot holes
until the Mounting Bracket is securely
attached to the mounting surface.
Mounting to Hollow Surface
1. Using a drill bit slightly smaller
than the Anchors, drill holes
in the marked locations.
2. Tap Anchors into the holes until they are
almost flush with mounting surface.
3. Position Mounting Bracket so that
Mounting Holes align with anchor holes.
Page 8 For technical questions, please call 1-888-866-5797.
4. Remove protective film from the Lens.
5. Attach Camera to Mounting Bracket,
then loosen Adjustment Knob, adjust
Camera as needed, then tighten
Adjustment Knob. (See Figure E.)
4. Drive Screws through mounting holes
in Base and into anchor holes until
the Mounting Bracket is securely
attached to the mounting surface.
5. Remove protective film from the Lens.
6. Attach Camera to Mounting Bracket,
then loosen Adjustment Knob, adjust
Camera as needed, then tighten
Adjustment Knob. (See Figure E.)
Adjustment
Knob
Figure E
Item 62367