Before Mounting - Bunker Hill Security 61208 Owner's Manual & Safety Instructions

Before mounting

1. Test Camera by connecting all cables
and making sure it functions properly.
2. Also test Camera in intended location
before mounting. When planning
mounting location and angle:
a. Take into consideration the length
of the Cable. Route the Cable so
as to avoid a tripping hazard.
b. Choose a location high enough so
that it is out of reach of children, but
still covers the desired viewing area.
c. Verify that installation surface
has no hidden utility lines before
drilling or driving screws.
d. To avoid mounting the Camera
upside down, make sure the
Hood is above the Lens.
e. Make sure no strong light will
shine directly into Camera Lens.
mounting
Solid Surface
1. Using a drill bit slightly smaller
than the Screws, drill pilot holes
into the marked locations.
2. Position Camera so that mounting
holes align with pilot holes.
hollow Surface
1. Using a drill bit slightly smaller
than the Anchors, drill holes
in the marked locations.
2. Tap Anchors into the holes until they are
almost flush with mounting surface.
3. Position Camera so that Mounting
Holes align with anchor holes.
note: Route Cable through slot on Base
to keep Base flush with mounting surface.
Item 61208
Downloaded from www.Manualslib.com
For technical questions, please call 1-800-444-3353.
manuals search engine
3. Using the Base as a template,
mark locations of mounting
holes on mounting surface.
note: Route Cable through slot on
Base to keep Base flush with mounting
surface while marking holes.
mounting
Cable
holes
Slot
Figure C
note: Route Cable through slot on Base
to keep Base flush with mounting surface.
3. Drive Screws through mounting
holes in Base and into pilot holes
until the Camera is securely
attached to the mounting surface.
4. Drive Screws through mounting
holes in Base and into anchor
holes until the Camera is securely
attached to the mounting surface.
Base
Page 7