Precautions For Power Connection - Nvidia DIGITS DEVBOX User Manual

Precautions for Power Connection

Power Cords
To reduce the risk of electric shock or damage to the equipment:

Use power cables provided with this product.

If you have to change the power cords for any reason, use an approved power cord. .

You must use a power cord rated for your product and for the voltage and current
marked on the electrical ratings label of the product. The voltage and current rating of
the cord must be greater than the voltage and current rating marked on the product. .

Make sure that the total ampere rating of all products plugged into an extension cord
or power strip does not exceed 80 percent of the ampere ratings limit for the
extension cord or power strip.

The product is equipped with a three-wire electrical grounding-type plug which has a
third pin for ground. This plug only fits into a grounded electrical power outlet.

Plug the power cord into a grounded (earthed) electrical outlet that is easily
accessible at all times.

Do not disable the power cord grounding plug. The grounding plug is an important
safety feature.

Do not place objects on AC power cords or cables. Arrange them so that no one may
accidentally step on or trip over them.

Do not pull on a cord or cable. When unplugging from the electrical outlet, grasp the
cord by the plug.

When possible, use one hand only to connect or disconnect cables.

Do not modify power cables or plugs. Consult a licensed electrician or your power
company for site modifications.
Power Supply

Ensure that the voltage and frequency of your power source match the voltage and
frequency inscribed on the equipment's electrical rating label. If you have the
question about the type of power source to use, contact your authorized service.

Connect to a properly wired and grounded electrical outlet, always follow your
local/national wiring rules.

The socket-outlet shall be installed near the equipment and shall be easily accessible.

If want to help protect your system from sudden, transient increases and decreases in
electrical power, a surge suppressor, line conditioner and so on could be used.

Never force a connector into a port. Check for obstructions on the port. If the
connector and port don't join with reasonable ease, they probably don't match. Make
DIGITS DevBox
Safety
29