Advertisement
WEDA
W50
R
5.4 Manual Cleaning
Make sure that the swich on the conrol box is set to manual.
Start by driving the pool vacuum around the walls in the pool and clean thereafter the entire pool bottom at
any pattern you may prefer.
5.5 Automatic Cleaning
Use the radio remote control to drive the pool vacuum to the selected starting position .
Five seconds after the last use of any button the cleaner goes back into automatic mode.
The cleaner works in fully automatic mode for three(3) hours.
The cleaner is controlled by the PLC in cooperation with laser and air sensors in combination with
built in timers
5.6 Recovering the W50 from the pool
Switch to manual mode on the control box.
Drive the vacuum towards the wall where it will be taken out of the pool.
Put down the radio remote control.
Pull the pool vacuum in the floating cable slowly towards you until you can reach the rope and later on grab it
in the handle bar.
Pull the W50 onto the pool side.
Drive the cleaner to its storage or onto the trolley.
Turn off the power and disconnect the power cable from the outlet.
Remove the filter bag and flush it with clean water. Allow it to dry off before next cleaning if possible.
Flush the cleaner with fresh water (also under the cover)
Look into the suction intake to make sure that no larger particles are caught in the pump.
Hide quick links:
Advertisement
