Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Weda W50
Summary of Contents for Weda W50
- Page 1 WEDA OPERATING MANUAL EDITION 1...
-
Page 2: Table Of Contents
WEDA Table of Content Weda Poolclener AB and Pool Vacuums Delivery specification Technical specification Installation Operating Instructions Service and Maintenance... -
Page 3: Weda Poolclener Ab And Pool Vacuums
The latest product in the Weda range is the W50. W50 is the smallest fully-automatic and semi-auto- matic pool vacuum in the Weda range. It is still designed to meet the needs of large public pools with a large amount of users. And it includes the Weda reliability and more then 30 years experience from pool-vacuum-design, usage and servicing. -
Page 4: Delivery Specification
WEDA Description The W50 Standard is designed to clean bottoms in rectangular shaped pools. The user has the option to choose between manual drive with a remote radio control or fully automatic “one-way” cleaning. “One way” cleaning makes the cleaner clean the bottom in parallel runs making a U-type turn as it hits the wall. -
Page 5: Installation
WEDA 3.2 Control Box Length x Width x Height 270x380x120 mm 11 x 15 x 5 inches Water protection IP 67 Primary Voltage 110/230 VAC Amperage primary side 10/4.9 A Motor protection setting 11/5.9A Fuses 16A/10A 3.3 Floating Cable (Umbilical) -
Page 6: Operating Instructions
WEDA 5. Operating Instructions 5.1 The Control Box The control panel is located on the top of the control box and has the following controls and options: ON/OFF Button with light Program selector Button With two (2) Positions, Man/Auto Timer 1... - Page 7 WEDA 5.2 The radio remote control The remote control is normally placed on top of the Control BoxSelect MAN control on the control box. The remote control is a four (4) channel radio transmitter with the following functions: 1. Forwards movement. Press once on forward button.
- Page 8 AUTO. The W50 is equipped with multiple laser sensors to detect the oncoming wall and initiate a turn and to detect the side wall at the far end of the pool.
-
Page 9: Service And Maintenance
For vacuums working no deeper than 5 meters (15 ft) depths the shaft seal should be greased after every 200 hours of cleaning. Use only food approved white grease Weda Part No WP 740388. Use the grease gun supplied with the cleaner. Remove the side plate an the left side to reach the nozzle on the vacuum. - Page 10 WEDA 6.4 Straight moving path settings To set a straight moving path the drive track tensions is adjusted on both sides of the cleaner (please see figure below). Release the 2 screws (1) and (2) and take off the side plate. Thereafter the slide rails can be adjusted by turning the screws number (3).
- Page 11 Do not drive the pool vacuum outside the pool water for more than 5 minutes per hour. The vacuum and the floating cable are cooled by the pool water. Use only WEDA Original parts for service at all times. One incorrectly used O-ring may cause costly damage to the pool vacuum.
- Page 12 WEDA 6.8 Problem handling Problem Reason / Remedy The vacuum does not pump or move 1. Fuse broken/Replace 2. GFCI or EFCB has shut off the power. 3. Over current relay has released and is not reset 4. Impeller blocked. Remove obstacle (Disconnect the power first) 5.
- Page 13 Weda underwater Weda, founded in Sweden, in 1919 is one of the oldest companies in the world in the pool cleaning industry. cleaning The range today consists of cleaners to fit everything technology from the smallest public pool up to large outdoor...
Need help?
Do you have a question about the W50 and is the answer not in the manual?
Questions and answers