Operation Using An Http Browser - NEC LT260 User Manual

APPENDIX

Operation Using an HTTP Browser

Overview
The use of HTTP server functions will allow control of the projector from a
web browser without the installation of special software. Please be sure to
use "Microsoft Internet Explorer 4.x" or a higher version for the web browser.
(This device uses "JavaScript" and "Cookies" and the browser should be
set to accept these functions. The setting method will vary depending on
the version of browser. Please refer to the help files and the other informa-
tion provided in your software.)
NOTE:
* The use of HTTP server functions is not available during Standby mode.
* The display's or button's response can be slowed down or operation may not be
accepted depending the settings of your network. Should this happen, consult
your network administrator.
* The projector may not respond if its buttons are repeatedly pressed in rapid
intervals. Should this happen, wait a moment and repeat. If you still can't get
any response, pull out and then re-insert the LAN card.
Access is gained to the HTTP server functions by specifying
http:// <the projector's IP address> /index.html
in the entry column of the URL.
CAUTION:
Do not use the HTTP Server functions and the Dynamic Image Utility in-
cluded on the supplied CD-ROM. Using both at the same time may result
in a connection failure or slow response.
E-135
http://www.pureglare.com.au