Controls And Markings - EMS 110 User Manual

Controls and Markings

Refer to figure 1 - Assembled Balance.
Display:-
On/Off Button:- To turn the balance on, press the On/Off button.
Enter Button
Select Button
The EMS serial number of the balance and month / year of manufacture
is shown on the label attached at the side of the balance.
The liquid crystal display gives a direct reading of
ultrasonic power in Watts.
Pressing either of the Tare buttons will zero the
display
To turn the balance off, press and hold down the
On/Off button.
When first turned on, the balance will default to show
grams. The Enter button will switch the display to the
customised output (Watts).
This button MUST ONLY be used to toggle
between grams and watts AFTER the Enter
button has been pressed. Incorrect use will allow
access to and possible corruption of conversion
factors.
Precision Ultrasound Balance
11