Acer Lenovo 3000 J Series User Manual page 72

Note: You will need a diskette drive on your computer or a USB diskette drive to
10. When the operation is complete, remove the diskette and click Quit.
Running diagnostics from the CD or diskettes
To run diagnostics from the diagnostic CD image or diagnostic diskettes that you
created, use the following procedure:
1. Make sure your computer is turned off.
2. If you are running diagnostics from diskettes using a USB diskette drive, plug
3. Insert the CD into the optical drive or the first diagnostic diskette into the
4. Restart the computer.
5. When the diagnostics program opens, follow the instructions on the screen.
6. When the program finishes, be sure to remove the CD or diskette from the
7. Select the diagnostic test you want to run. Press the F1 key for additional help.
Running diagnostics from the Rescue and Recovery workspace
If you did not create a diagnostic CD image or diagnostic diskettes, you can run
the PC-Doctor for DOS diagnostic program from the Rescue and Recovery
workspace. To run diagnostics from the Rescue and Recovery workspace, use the
following procedure:
1. Shut down the operating system and turn off the computer.
2. Repeatedly press and release the F11 key as you turn on the computer.
3. When you hear beeps or see a logo screen, stop pressing the F11 key. The
4. From the Rescue and Recovery workspace, select Diagnose hardware.
56
User Guide
complete this procedure.
1. Shut down the operating system and turn off the computer.
2. If you are using a USB diskette drive, plug it into the computer.
3. Repeatedly press and release the F11 key as you turn on the computer.
4. When you hear beeps or see a logo screen, stop pressing the F11 key. The
Rescue and Recovery workspace opens.
Note: For some models, press the Esc key to enter Rescue and Recovery.
5. From the Rescue and Recovery workspace, select Create diagnostic disks.
6. Follow the instructions on the screen.
7. When prompted, insert a blank, formatted diskette into the diskette drive and
continue to follow the instructions on the screen.
8. When the operation is complete, remove the diskette and click Quit.
9. Insert another blank, formatted diskette into the diskette drive and continue to
follow the instructions on the screen.
in the USB device.
diskette drive.
Note: If the diagnostic program does not start, you might not have your optical
drive or diskette drive set as a startable device. See "Selecting a startup
device" on page 49 for instructions on how to change the startup device.
Note: If you are running diagnostics from a diskette, when prompted, remove
the first diskette and insert the second diskette.
drive.
Rescue and Recovery workspace opens.
Note: For some models, press the Esc key to enter Rescue and Recovery.