Table of Contents
Advertisement
B-9
AUXILIARY POWER
The RANGER 8+ DIESEL can provide up to 9,000
watts of 115/230 volts AC, Single phase 60 HZ power
for continuous use. The front of the machine includes
three receptacles for connecting AC power Plugs, one
50 amp 115/230 volt NEMA 14-50R receptacle and
two 15 amp 115 volt NEMA 5-15R receptacles. Do
not connect any plugs that connect to the power
receptacles in parallel.
Start the engine and set the "IDLER" control switch to
the desired operating mode. Set the "CONTROL" to
10. Voltage is now correct at the receptacles for auxil-
iary power.
Most 1.5 hp AC single phase motors can be started if
there is no load on the motor or other load connected
to the machine. Larger motors through 2 hp can be
run provided the receptacle rating as previously stated
RANGER 8+ DIESEL SIMULTANEOUS WELDING AND POWER LOADS
Output
Selector
Setting
MAX
175
125
90
70
50
NO WELDING
NOTE: Voltage and permissible watts decrease as "CONTROL" is adjusted to settings less than 10. It is recommended that
at settings less than 10, only incandescent lighting loads be connected to the auxiliary power receptacles.
OPERATION
(OUTPUT CONTROL SET AT 10)
TABLE B.4
Welding
Output
Power Watts
Amps
(Unity Power
225 DC / 250 AC
175
125
90
70
50
RANGER 8+ DIESEL
is not exceeded. This may necessitate 230 volt oper-
ation only.
SIMULTANEOUS WELDING AND POWER
LOADS
Auxiliary power ratings are with no welding load.
Simultaneous welding and power loads are permitted
by the following table. The permissible currents
shown assume that current is being drawn from either
the 115 volt or 230 volt supply (not both at the same
time).
Permissible
Permissible
Auxiliary Current in
Amperes @ 115V
Factor)
NONE
2100
3800
5000
5600
6300
9000
Permissible
Auxiliary Current
in Amperes @
230V
0
0
20
10
32
16
42
21
23
46
26
52
80
40
B-9
Advertisement
Table of Contents
