Maintenance & Adjustment - Cub Cadet JS1150 Operator's Manual

Maintenance & Adjustments
Maintenance
WARNING!
repairs always stop engine.
Engine
Refer to the Honda Owner's Manual for all engine maintenance
procedures and instructions.
NOTE: Maintenance, repair, or replacement of the emission
control devices and systems which are being done at owner's
expense may be performed by any engine repair establishment
or individual. Warranty repairs must be performed by a Cub
Cadet Dealer.
Air Cleaner
Service the pre-cleaner and cartridge/air cleaner element as
instructed in the Honda Owner's Manual.
Spark Plug
The spark plug should be cleaned and the gap reset once a
season. Refer to the Honda Owner's Manual for correct plug type
and gap specifications.
Cleaning the Blower
Any fuel or oil spilled on the machine should be wiped off
promptly. Do NOT allow debris to accumulate around the cooling
fins of the engine, the fan intake area or on any other part of the
machine.
WARNING!
engine, muffler and surrounding metal surfaces will
be hot and can cause burns to the skin. Exercise
caution to avoid burns.
10
Before performing any maintenance or
If the engine has been recently run, the
Lubrication
WARNING!
Before lubricating, repairing, or
inspecting, always stop engine.
Rear Wheels
Lubricate the rear axles with a spray lubricant once a season.
Front Wheel
The caster and each side of the front wheel axle is equipped
with a grease fitting. See Fig. 6-1. Lubricate with a No. 2 multi-
purpose grease applied with a grease gun after every 50 hours of
operation.
Figure 6-1
6