JVC KD-G701 Service Manual page 18

QQ
3.2.7 Removing the pickup unit 3 7 63 1515 0
(See Figs.14 to 18)
• Prior to performing the following procedure, remove the top
cover, connector board and chassis unit.
(1) Remove the screw D and pull out the pu. shaft holder from
the pu. shaft.
(2) Remove the screw E attaching the feed sw. holder.
(3) Move the part e of the pickup unit upward with the pu. shaft
and the feed sw. holder, then release the joint f of the feed
sw. holder in the direction of the arrow. The joint g of the
pickup unit and the feed rack is released, and the feed sw.
holder comes off.
(4) Remove the pu. shaft from the pickup unit.
(5) Remove the screw F attaching the feed rack to the pickup
unit.
3.2.8 Reattaching the pickup unit
(See Figs.14 to 17)
(1) Reattach the feed rack to the pickup unit using the screw F.
(2) Reattach the feed sw. holder to the feed rack while setting
the joint g to the slot of the feed rack and setting the part f
of the feed rack to the switch of the feed sw. holder correct-
ly.
(3) As the feed sw. holder is temporarily attached to the pickup
unit, set to the gear of the joint g and to the bending part of
the chassis (joint h) at a time.
CAUTION:
Make sure that the part i on the underside of the feed
rack is certainly inserted to the slot j of the change lock
lever.
(4) Reattach the feed sw. holder using the screw E.
TE
L 13942296513
(5) Reattach the pu. shaft to the pickup unit. Reattach the pu.
shaft holder to the pu. shaft using the screw D.
Joint f
Pu. shaft
D
Pu. shaft holder
Fig.14
www
.
1-18 (No.MA057)
http://www.xiaoyu163.com
Feed sw. holder
E
Joint g
Part e
Pickup unit
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Part e
Feed rack
Pickup unit
Part i
E
Slot j
Joint g
Feed sw.
holder
Q Q
3 6 7 1 3 1 5
F
Pickup unit
Joint g
Feed rack
Feed sw. holder
co
.
9 4 2 8
Pickup unit
Feed sw. holder
Fig.15
Pu. shaft
D
Joint f
Joint h
Pu. shaft
holder
Fig.16
0 5 8 2 9 9 4 2 8
Feed rack
Fig.17
Pickup unit
Joint f
Fig.18
m
9 9
9 9