Lincoln Electric POWER WAVE C300 CE Operator's Manual page 49

B-29
Parameter
P.5 Procedure Change Method
Selects how remote procedure selection (A/B) will be made. The selected procedure can be
changed locally at the user interface by pressing the 'A-Gun-B' button. The following methods
can be used to remotely change the selected procedure:
• Use an external switch wired to the procedure select input.
• Quickly releasing and re-pulling the gun trigger.
• Using a dual-schedule gun which incorporates a procedure select switch in the trigger mecha-
nism (pulling the trigger more than half way changes the procedure from A to B).
The possible values for this parameter are:
• External Switch = Procedure selection may only be performed at the memory panel or an
external switch (e.g. K683).
• Quick Trigger = The selected procedure can be changed remotely by releasing and re-pulling
the trigger quickly while welding. This feature is disabled in 4-Step trigger mode. The external
procedure switch is disabled. To operate:
1. Select "GUN" on the memory panel.
2. Start the weld by pulling the gun trigger. The system will weld with procedure A settings.
3. While welding, quickly release then pull the gun trigger once. The system will switch to
procedure B settings. Repeat to switch back to procedure A settings. The procedure can
be changed as many times as needed during the weld.
4. Release the trigger to stop welding. The system will automatically return to procedure A
settings.
• Integral TrigProc = When using a Magnum DS dual-schedule gun (or similar) that incorpo-
rates a procedure switch in the gun trigger mechanism. While welding in 2-step, machine
operation is identical to the "External Switch" selection. When welding in 4-step, additional
logic prevents procedure A from being re-selected when the trigger is released at step 2 of the
4-step weld sequence. The machine will always operate in 2-step if a weld is made exclusive-
ly in procedure A, regardless of the 2/4 step switch position (this is intended to simplify tack
welding when using a dual-schedule gun in 4-step).
P.6 Stall Factor Adjustment
This option allows the adjustment of the stall factor in Push/Pull operation. The stall factor con-
trols the stall torque of the push motor when using a push-pull gun. The wire feeder is factory-
set to not stall unless there is a large resistance to feeding wire. The stall factor can be reduced
to stall more easily and possibly prevent bird nesting. However, low stall factors can cause
motor stalling during normal welding conditions, which results in the wire burning back to the tip
or rapid tack welds. If you are experiencing bird nests, check for other feeding problems before
adjusting the stall factor. The default value for the stall factor is 75, with a range of 5 to 100.
OPERATION
USER DEFINED PARAMETERS
Definition
POWER WAVE® C300 CE
B-29