CAUTION: No user serviceable parts inside, refer servicing to qualified personnel only. • Olsson amplifier and loudspeaker systems are capable of producing very high sound pressure levels • which may cause temporary or permanent hearing damage. Use care when setting and adjusting...
• VARSAMHET: Inga delar inuti apparaten kan repareras av användaren, anlita kvalificerad • servicepersonal. Förstärkare och högtalarsystem från Olsson Amps kan producera höga ljudnivåer som kan orsaka • temporära eller permanenta hörselskador. Var försiktig vid inställning och justering av ljudvolymen.
Stage 40 Nord Amp Together with Mikael “Nord” Andersson we have developed Stage 40 Nord, which is an all-tube hand- wired amp built to meet all modern requirements. The amp has dual channels and is designed to work excellent with all type of guitar microphones.
Stage 40 Nord 1x12” amp –select 8ohm for the internal speaker Stage 40 Nord 2x12” amp - select 4ohm for the internal speakers D. FOOTSWITCH JACK – Connect the footswitch to this jack. VACUUM TUBES Replace tubes only with the same type and ratings as specified.
Control panel E. POWER SWITCH – Turns the amplifier on-off as indicated by the jewel unit. F. STANDBY – When the amplifier is on, Standby will mute all audio output from the amplifier. Use Standby during short breaks to avoid the tube warm up delay. Select Standby for the first 60 seconds when switching the amplifier ON to extend tube life.
Changing power tubes Note: When changing power tubes you must always adjust the BIAS setting inside the amp. Leave the bias adjustment to qualified service personnel. Never open the amp by your self, there is high voltage inside the enclosure. We deliver the amp with EL34 power tubes from Electro Harmonix.
Page 8
A PRODUCT OF: OLSSON AMPS STOCKHOLM, SWEDEN 2015 – STAGE 40 NORD, OWNER’S MANUAL - VERSION 1.0, 060131007...
Need help?
Do you have a question about the STAGE 40 NORD and is the answer not in the manual?
Questions and answers