Idle Down (Air Only) - FUTABA 14SG S.Bus2 Instruction Manual

IDLE DOWN
The Idle Down function lowers the engine to
its idle position. Like Throttle Cut, this is usually
accomplished by flipping a switch with the throttle
stick at idle. The action is not functional at high
throttle to avoid accidental dead sticks. The
switch's location and direction must be chosen, as
it defaults to NULL.
● Select [IDLE DOWN] in the Linkage menu and
access the setup screen shown below by touching
the RTN button.
● Select the function name
and return to the Linkage
menu by touching the
R T N b u t t o n . O r t h e
H O M E / E X I T b u t t o n i s
pushed.
Idle down setting procedure
1. Activate the function:
Move the cursor to the [ACT] item and touch
the RTN button to switch to the data input
mode.
Select the ACT mode by scrolling the touch
sensor.
*The display blinks.
Touch the RTN button to activate the
function and return to the cursor mode.
2. Switch selection:
Move the cursor to the [SW] item and access
the switch setup screen by touching the RTN
button. Select the switch and ON direction.
*For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.
3. Offset rate setting:
Move the cursor to the [OFFSET] item and
touch the RTN button to switch to the data
input mode.
Adjust the servo offset rate at idle down
operation by scrolling the touch sensor.
Initial value: 0%
Adjustment range: -100%~0%~+100%
* When a minus rate is input, an offset is applied at the high
side.
*Maximum offset amount is near maximum slow.
84 <Functions of Linkage Menu>
Lowers the engine idling speed.(airplane only)
● Current throttle position
<SensorTouch™>
* When the RTN button is touched for one second, the offset
rate is reset to the initial value.
Touch the RTN button to end the adjustment
and return to the cursor mode.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value