Program Mix - FUTABA 14SG S.Bus2 Instruction Manual

PROG. MIX
Programmable mixing may be used to correct
undesired tendencies of the aircraft, and it may also be
used for unusual control configurations. Mixing means
that the motion of a command channel, called the
"master," is added to the motion of the mixed channel,
called "slave."
You may choose to have the Master's trim added to
the Slave channel response ("Trim" setting). The mixing
curve (Linear/5-point) can be changed. You may select
● Select [PROG. MIX] at the Model menu and access
the setup screen shown below by touching the
RTN button.
● Select the function name
and return to the Model
menu by touching the
R T N b u t t o n . O r t h e
H O M E / E X I T b u t t o n i s
pushed.
●Mix #
● Move the cursor to the mix # whose function you want to activate
and access the setup screen by touching the RTN button.
●Mixing rate (Left/right, up/down)
[Linear curve]
●Curve selection ●Offset rate(X, Y)
●Current mix No.
●Link setting
●Slave CH
●Trim mode setting
●Master CH
Program mixing which can be freely customized. Up to five mixings
can be used for each model. [All model types]
Mixing ON/OFF switch, control or you may choose to
have mixing remaining on all the time.
The Programmable mixing includes a powerful link
function, which allows Programmable mixing to be
linked with the special mixing functions, or with other
programmable mixing functions. The link function can
be set up for Master and Slave channel individually.
Mix setup screen call
●Curve selection
●Switch selection Prog. mix setting procedure
●ON/OFF
●Activate the function.
Move the cursor to the [ACT] item and touch
the RTN button to switch to the data input
mode.
Select the ACT mode by scrolling the touch
sensor.
*The display blinks.
Touch the RTN button to activate the
function and return to the cursor mode.
*The function is activated. (ON or OFF display)
*ON/OFF switch and mix rate are not set even though the
<SensorTouch™>
● To next page
[5-point curve]
●Point rate (point1-5)
function is activated.
<Model Menu (Common Functions)>
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
111