Heating Elements; Residual Heat Indicator; Operation; Main Power Switch - Bosch NETP066SUC Use And Care Manual

Heating elements

Element
Single element
$
Dual element
ð
Triple element
ò
(NETP666SUC only)
Bridge element
à
(NETP666SUC only)

Residual heat indicator

The cooktop is equipped with a residual heat indicator
for each element. It shows you which elements are still
hot. Avoid touching the indicated elements.
If an is shown on the display, the element is still hot.
•
You could use it, for example, to keep a small quantity of

Operation

Main power switch

Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the On/Off touch key until the indicator above the
main switch and the symbols
turn on.
Turning the cooktop off
Touch the On/Off touch key. The __ indicator goes out.
The cooktop is switched off. The residual heat indicators
will remain on until the elements have cooled off
sufficiently.
Note: The cooktop switches off automatically when all
the elements have been switched off for more than
10 seconds.
If residual heat is still present when the cooktop is turned
on, • / œ will appear in the heating element display.
10
Turning on and off
Always use cookware of a suitable size.
The size of these elements can be matched to your pan size. The heating element must
be turned on.
Turning off the outer heating ring: Touch
Adding: Touch ö again. The
On this element you can turn the medium and large heating rings off. The heating
element must be turned on.
Turning off the outer heating ring: Touch
Turning off the middle heating ring: Touch
When you turn the heating element on again, all of the heating rings will be on.
The Bridge element combines two individual heating elements into one long griddle zone.
This configuration is ideal for griddles and large pans.
Note: : Do not use cookware larger than 17" x 10" (432 x 254 mm).
Turning on the Bridge element: Touch one of the two
heating element, then touch the
are now selected. ‹ appears in both displays. Within the next 10 seconds select the
desired heat setting (1-9). The Bridge element and both individual heating elements are
now on.
Changing the heat setting: Touch one of the two
selecting the Bridge element, and set the new heat level within the next 10 seconds.
Turning off the Bridge element feature: Touch one of the two
the Bridge element, and select 0 from the number keys.
heating elements will turn off and the residual heat indicator will appear.
for the heating elements
$
. The
ö ð
ð display will turn on.
ö . The ò
again. The
ö
key. The symbol will appear; both heating elements
à à
touch keys for
$
food warm or to melt a chocolate coating. As the element
continues to cool, the display changes to
goes out once the element has cooled sufficiently.
The residual heat indicator will automatically come on
after a power failure. The display lights up for
approximately 30 minutes.
Main power switch
Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the On/Off touch key until the indicator above the
main switch and the symbols
turn on.
Turning the cooktop off
Touch the On/Off touch key. The __ indicator goes out.
The cooktop is switched off. The residual heat indicators
will remain on until the elements have cooled off
sufficiently.
Note: The cooktop switches off automatically when all
the elements have been switched off for more than
15 seconds.
If residual heat is still present when the cooktop is turned
on, / will appear in the heating element display.
• œ
display will turn off.
display will turn off.
display will turn off.
ð
touch keys for selecting the
$
$ touch keys for selecting
appears in both displays. The
‹
. The display
œ
for the heating elements
$