Heating Elements; Residual Heat Indicator; Operation; Main Power Switch - Bosch NET8066UC Use And Care Manual

Heating elements

Element
Single element
$
Dual element
ð
Bridge element
à

Residual heat indicator

The cooktop is equipped with a residual heat indicator
for each element. It shows you which elements are still
hot. Avoid touching the indicated elements.
If an is shown on the display, the element is still hot.
•
You could use it, for example, to keep a small quantity of

Operation

Main power switch

Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the On/Off touch key until the indicator above the
main switch and the temperature level indicators
to the heating elements turn on.
Turning the cooktop off
Touch the On/Off touch key. The indicator above the
On/Off key goes out. The cooktop is switched off. The
residual heat indicators will remain on until the elements
have cooled off sufficiently.
10
Turning on and off
Single elements have only one size cooking surface.
Always use cookware of a suitable size.
The size of these elements can be matched to your pan size. The heating element
must be turned on.
Turning off the outer heating ribbon: Touch
Adding the outer heating ribbon: Touch
The Bridge element combines two individual heating elements into one long griddle
zone. This configuration is ideal for griddles and large pans.
Note: Do not use cookware larger than 17" x 10" (432 x 254 mm).
Turning on the Bridge element: Touch one of the two
heating element, then touch the
ments are now selected.
select the desired heat setting (1-9). The Bridge element and both individual heating
elements are now on.
Changing the heat setting: Touch one of the two
Bridge element, and set the new heat level within the next 10 seconds.
Turning off the Bridge element feature: Touch one of the two
selecting the Bridge element, and select 0 from the number keys.
displays. The heating elements will turn off and the residual heat indicator will appear.
next
‹
. The
ö
again. The
ö
key. The symbol will appear; both heating ele-
à à
appears in both displays. Within the next 10 seconds
‹
food warm or to melt a chocolate coating. As the element
continues to cool, the display changes to
goes out once the element has cooled sufficiently.
The residual heat indicator will automatically come on
after a power failure. The display lights up for
approximately 30 minutes.
Notes
The cooktop switches off automatically when all the
▯
elements have been switched off for more than
10 seconds.
The settings will be stored for 4 seconds after turning
▯
off the cooktop. If you turn the cooktop back on during
that time the cooktop will continue with those settings.
The residual heat indicator remains lit until the
▯
elements have cooled down sufficiently.
displayed next to the corresponding element symbol.

Setting the cooktop

This section will show you how to set the elements. The
table contains details on the heat settings for a variety of
dishes.
Setting the element
Set the desired heat setting on the control panel.
Heat setting 1 = lowest power
Heat setting 9 = highest power
Every heat setting has an intermediate setting. This is
marked in the control panel with the
display will turn off.
ð
display will turn on.
ð
touch keys for selecting the
$
touch keys for selecting the
$
touch keys for
$
appears in both
‹
. The display
œ
•
symbol.
û
/ œ is