Epson EB-955WH User Manual page 131

Problem Solving
Indicators
Power supply Status
Blue - Flashing Cool down status
Blue - Lit
Blue - Lit
Refer to the following table to see what the indicators mean and how to remedy problems that they indicate.
If all indicators are off, check that the power cord is connected correctly and that the power is being supplied normally.
Sometimes, when the power cord is unplugged, the [
Indicators
Power sup Status
ply
Off Blue - Flash-
ing
Off Blue - Flash-
ing
Off Blue - Flash-
ing
Status
Normal status
Blue - Lit
] power indicator remains lit for a short period, but this is not a fault.
t
Cause
Lamp Tempera
ture
Internal Error
Orange - Off
Flashing
Fan Error
Sensor Error
Off Orange -
Flashing
High Temp Error
(Overheating)
Off Orange - Lit
This is the status immediately after turning off the projector. In this status, all buttons are disabled.
The projector is projecting.
Stop using the projector, remove the power plug from the electrical outlet, and contact your local
dealer or the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
Stop using the projector, remove the power plug from the electrical outlet, and contact your local
dealer or the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
The lamp turns off automatically and projection stops. Wait for about five minutes. After about five
minutes the projector switches to standby mode, so check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned
against a wall.
• If the air filter is clogged, clean or replace it.
s "Cleaning the Air Filter" p.146, "Replacing the Air Filter"
If the error continues after checking the points above, stop using the projector, remove the power
plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
Epson Projector Contact List
s
When using at an altitude of 1500 m or more, set High Altitude Mode to On.
s "Extended Menu" p.106
Explanation
Remedy or Status
p.151
131