Adding A New Device Using Network Discovery - Toshiba e-studio2500c Scanning Manual

Color Settings Tab
In the Color Settings tab, you can set the following options.
1) Saturation
Specify the saturation level of scanned images. The saturation level is selectable from -3
(dull) to 3 (bright) in increments of 1, using a scroll bar.
This cannot be set when the Remote Scan driver is connected to the e-STUDIO451c Series,
e-STUDIO850 Series, e-STUDIO452 Series, or e-STUDIO282 Series.
2) RGB Adjustment
Specify each density level of red (R), green (G) and blue (B) in scanned images. The density
level is selectable from -4 (low) to 4 (high) in increments of 1, using a scroll bar.
This cannot be set when the Remote Scan driver is connected to the e-STUDIO451c Series,
e-STUDIO850 Series, e-STUDIO452 Series, or e-STUDIO282 Series.

Adding a New Device Using Network Discovery

You can add a new connection to other equipment by searching the equipment in your network.
This enables you to add several devices that you can connect using the Remote Scan driver.
To add a new connection, click the [Devices] menu and select [Discovery]. The TopAccessDoc-
Mon Local Discovery dialog box appears and discovers the devices in your network to add a
new connection. For further instruction on how to discover the devices using the TopAccess-
DocMon Local Discovery dialog box, see the following section.
P.136 "When You Are Running the First Time"
After you add other devices in the connection list, you can change the target equipment by
selecting the [Select e-STUDIO] command under the [Devices] menu.
P.144 "Changing the Target Device"
1
2
Scanning Remotely Using Remote Scan Driver 143