Tools And Supplies Needed; Inspect Fireplace And Components; Fireplace System Requirements - Heatilator BIR50-B Installation Manual

C. Tools and Supplies Needed
Before beginning the installation be sure the following
tools and building supplies are available:
Reciprocating saw
Pliers
Hammer
Phillips screwdriver
Flat blade screwdriver
Plumb line
Level
1/2-3/4 in. length, #6 or #8 self-drilling screws
Misc. screws and nails
D. Inspect Fireplace and Components
WARNING! Risk of Fire and/or Explosion!
parts could impair safe operation. DO NOT install dam-
aged, incomplete or substitute components. Keep fi re-
place dry.
• Remove fi replace and components from packaging and
inspect for damage.
• Vent system components and doors are shipped in
separate packages.
• Report to your dealer any parts damaged in shipment.
• Read all the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety
and benefi t.
8 Heatilator • Birmingham BIR50-B Installation Manual • 4059-701 • Rev B • 2/6/13
Framing material
Non-combustible sealant
Gloves
Framing square
Electric drill and bits
Safety glasses
Tape measure
Damaged
E. Fireplace System Requirements
The Heatilator fi replace system requirements consist of
the following:
• Fireplace
- Molded brick panels (hearth panel Included with
fi replace, side and back panels sold separately)
- Firescreen (included with fi replace)
- Hearth Extension (sold separately)
- Grate (included with fi replace)
• Outside Air System
- Air Inlet Hood (included with fi replace)
- Flex (required, sold separately)
• Chimney System
- Attic Insulation Shield (sold separately)
- Chimney termination cap (sold separately)
• Non-combustible fi nish material