Table of Contents
Advertisement
4
Insert the paper tray into the fax machine, making sure it clicks
into place.
5
Replace the paper tray cover.
•
The paper tray cover also serves as a tray for original docu-
ments which come out of the fax after scanning for transmis-
sion or copying. You can pull out the cover as needed to en-
sure that it catches the documents.
6
Your fax has been set at the factory to print on regular paper. If
you have loaded Sharp FO-16NC paper, you must change this
setting to "HIGH QUALITY". Press the "FUNCTION" key, the "6"
key, the "
" key two times, and then press "1" to select regular,
or "2" to select Sharp high quality paper. When finished, press the
STOP key. Be sure to change this setting again if you change
back to regular paper.
F U N C T I O N
6
1
S T O P
2
o r
5. Clearing paper jams
If a document doesn't feed properly during transmission or copying,
or DOCUMENT JAMMED appears in the display, first try pressing the
START key. If the document doesn't feed out, open the operation
panel (grasp the front edge at the "PANEL RELEASE" mark and pull
up) and pull it out gently.
1
Grasp the finger hold on the right side of the printing compartment
cover, and pull up to open the cover.
2
Push the green levers back on each side of the printing compart-
ment, and rotate the printing head frame up and to the rear.
•
Caution! The printing head (the strip of metal on the under-
side of the frame) applies heat to the printing film. It
may be hot if a document has just been printed.
3
Remove the imaging film from the printing compartment and set it
on a sheet of paper.
4
Remove the paper tray from the fax.
1 – 7
FO-1850TH
Advertisement
Table of Contents
