Advertisement

ATAG
MC4111L
MA4111L

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MC4111L and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Atag MC4111L

  • Page 1 ATAG MC4111L MA4111L...
  • Page 2: Table Of Contents

    MC4111L / MAG 690 Technische informatie THE "MOBI" OVEN ............................4 1.1. - Control panel for ATAG Combi and Solo models..................5 1.2. - Control panel for PELGRIM Combi and Solo models................6 1.3. - Installation............................. 7 1.4. - Electric connection..........................8 USE ................................
  • Page 3 15.1. - Important instructions ........................... 35 15.2. - Conditions of entry ..........................35 15.3. - Run of the test program........................35 16 - ELECTRICAL DIAGRAM ATAG COMBI ...................... 38 17 - ELECTRONIC CARD ATAG COMBI......................39 18 - TEST PROGRAM ATAG COMBI ......................... 40 18.1.
  • Page 4: The "Mobi" Oven

    • Distributor of waves : embossing located on the left wall designed to splinter the flow of waves. • The control panel : With height buttons for ATAG With four buttons and two knobs for PELGRIM...
  • Page 5: Control Panel For Atag Combi And Solo Models

    MC4111L / MAG 690 Technische Documentatie 1.1. - Control panel for ATAG Combi and Solo models A) The START/STOP button lets you begin a program, interupt or cancel a program in progress. B and C) The - / + buttons allow you to adjust the program length, the weight , the temperature, the time, the food category, and power levels.
  • Page 6: Control Panel For Pelgrim Combi And Solo Models

    MC4111L /MAG 690 Technische documentatie 1.2. - Control panel for PELGRIM Combi and Solo models A) The - / + selector knob allows you to adjust the time, the programme length, the power levels, the food category, the food portion’s weight, as well as the temperature for a fan cooking programme.
  • Page 7: Installation

    MC4111L / MAG 690 Technische Documentatie 1.3. - Installation 1.3.1. - Build-in The appliance may be installed beneath a work surface or in column housing (open or closed) which has the required built-in measurements. The oven has an optimised air flow which makes it possible to obtain a correct operation of the appliance and remarkable results of cooking by respecting the following instructions: •...
  • Page 8: Electric Connection

    MC4111L / MAG 690 Technische documentatie 1.4. - Electric connection Before connecting of the appliance, check that it has not been damaged during the transport (Door or deformed seal). Check that : The electrical installation has sufficient voltage. The supply cables are in good condition.
  • Page 9: Use

    MC4111L / MAG 690 Technische Documentatie 2.1. - How to set / Change the time After connecting your appliance or after a prolonged power failure. Ø To set the clock • Flashes in the display. • Press the buttons or turn the selector to set the time, ex.
  • Page 10: Cooking Guides

    MC4111L / MAG 690 Technische Documentatie 2.3. - Cooking Guides 2.3.1. - Automatic defrosting guide 2.3.2. - High grill guide Place the food item on the grill and insert at level 3. Turn the food halfway through cooking. 2.3.3. - Turbo grill guide Place the food item in a dish on the grill at insertion level 1 Turn the food halfway through cooking.
  • Page 11 MC4111L / MAG 690 Technische Documentatie 2.3.5. - Grill + microwave guide 2.3.6. - Fan cooking guide...
  • Page 12: Using A Microwave Oven

    MICROWAVE OVEN MOBI PRINCIPE Formation technique USING A MICROWAVE OVEN To prevent the deterioration of the appliance, never operate it empty. 3.1. - Dishes Do not use metallic or circled with metal dishes, tin foil, plates with golden or silver line, crystal glasses (containing lead).
  • Page 13: Principle Of The Mobi Microwave Oven

    MC4011L / MAG 690 Technische Documentatie PRINCIPLE OF THE MOBI MICROWAVE OVEN 4.1. - Constitution The MOBI microwave oven comprises a microwave transmitter called magnetron. The emitted waves are confined in a recess called cavity. This cavity is closed by a door coupled to a safety device to avoid the emission of waves outside the oven.
  • Page 14: The Cooling System

    MC4111L / MAG 690 Technische Documentatie 4.3. - The cooling system The double blower takes the air by an entry located between the panel and the oven door. This air will cool all the components located in the upper part of the oven, and particularly the electronic card, but also all the other elements.
  • Page 15: Principle Of The Shutter Operation

    MC4111L / MAG 690 Technical Training 4.4. - Principle of the shutter operation The "Damper" shutter consists of two parts used for blocking the air inlets and outlets of the cavity. Depending on the desired cooking mode (Microwave, combined, traditional), the printed circuit board controls a "Wax actuator"...
  • Page 16 MC4111L / MAG 690 Technische Documentatie 4.4.2. - Shutter position in Combined or Traditional mode In Combined or Traditional mode, the shutter is open (up position), the air arriving from the right- hand turbine ventilates the magnetron and then is deflected towards an opening located near the magnetron.
  • Page 17: Door Lock

    MC4111L / MAG 690 Technical Training 4.5. - Door lock The door imperatively must be closed during the magnetron operation. It is fitted with a mechanical locking system, which controls the switches and the electrical power supply to the appliance. The switches only operate if the door is properly closed.
  • Page 18: The Various Cooking Modes

    MC4111L / MAG 690 Technische Documentatie 4.6. - The various cooking modes 4.6.1. - The microwave mode The magnetron is monitored. The set point power is comprised between 100W and 1000W. The power set point (1000W maximum) and the operating duration (59 min - 59 s maximum) are transmitted by the display board.
  • Page 19: Power Supply To Power Circuit

    MC4111L / MAG 690 Technical Training POWER SUPPLY TO POWER CIRCUIT The transformer primary winding is energized parallel-mounted relay triac. The triac is made conductive when the voltage is maximum, in order to have minimum current (owing to the phase shift related to the...
  • Page 20: The Different Components

    MC4111L / MAG 690 Technische documentatie THE DIFFERENT COMPONENTS Designation Function Characteristics In grill function, it makes it possible to Metallic grid brown food. In Fan cooking: To pose the dishes on the grid in low position to obtain a better distribution of heat and optimal of cooking results.
  • Page 21 MC4111L / MAG 690 Technische documentatie Designation Function Characteristics • Turntable motor Synchronous motor without preferential 230/240 V∼ rotating direction. • 4,2 t/min It is protected from overflow by a plastic • 15,6 KΩ protector. • It can be dismantled when opening the metal sheet of the bottom with a cutting plier.
  • Page 22 MC4111L / MAG 690 Technische documentatie Designation Function Characteristics Circular heating element and its This ventilated heating element is only Resistor thermostat used for the ‘COMBI’ models • 230 V∼ • 1600 W • 32,5 Ω Thermostat • 130°C •...
  • Page 23 MC4111L / MAG 690 Technische documentatie Designation Function Characteristics • Thermal Activator When Thermal activator is on, the shutter 220/240V~ is open. • • 830 Ω • Head in Teflon Panel assembly principle is the same as EURO oven Panel decor fixed with clips...
  • Page 24: Electrical Diagram Pelgrim Solo

    MC4111L / MAG 690 Technische documentatie ELECTRICAL DIAGRAM PELGRIM SOLO...
  • Page 25: Electronic Card Pelgrim Solo

    MC4111L / MAG 690 Technische documentatie ELECTRONIC CARD PELGRIM SOLO ON THE OHMMETER Mark Component 60 Ω Ph – Fan motor Fan motor 192 Ω Ph - Lamp Lamp Ph – Turntable motor Turntable motor 15,7 kΩ Controls must be done over voltage with connectors disconnected...
  • Page 26: Test Program Pelgrim Solo

    MC4111L / MAG 690 Technische documentatie TEST PROGRAM PELGRIM SOLO 9.1. - Important instructions • To place a container filled with water in the oven (for the tests in microwave modes). • To connect (if possible) an ammeter on the power supply of the oven.
  • Page 27 MC4111L / MAG 690 Technische documentatie Step Run and display Remarks Step • Right rotary switch checking Right rotary switch checking NO ⇒ If connections to power card are OK, then Right rotary switch or display out of order. Continue the test •...
  • Page 28 MC4111L / MAG 690 Technische documentatie Step Run and display Remarks Step • The magnetron, The cooling fan, the lamp, the Checking the Microwaves function turntable motor are on. I absorbed = 4,6A NO ⇒ If components, fuse, door switch, thermostat, transformer, diode, capacitor and wiring OK then Power card out of order.
  • Page 29: Electrical Diagram Atag Solo

    MC4111L / MAG 690 Technische documentatie 10 - ELECTRICAL DIAGRAM ATAG SOLO...
  • Page 30: Electronic Card Atag Solo

    MC4111L / MAG 690 Technische documentatie 11 - ELECTRONIC CARD ATAG SOLO ON THE OHMMETER Mark Component 60 Ω Ph – Fan motor Fan motor 192 Ω Ph - Lamp Lamp Ph – Turntable motor Turntable motor 15,7 kΩ controls must be done over voltage with connectors disconnected...
  • Page 31: Test Program Atag Solo

    MC4111L / MAG 690 Technische documentatie 12 - TEST PROGRAM ATAG SOLO 12.1. - Important instructions • To place a container filled with water in the oven (for the tests in microwave modes). • To connect (if possible) an ammeter on the power supply of the oven.
  • Page 32 MC4111L / MAG 690 Technische documentatie Step Run and display Remarks • Buttons checking Right switch board checking (+) NO ⇒ If connections to power card are OK, then Right switch board out of order. Continue the test • Right switch board checking (ENTER) Buttons checking NO ⇒...
  • Page 33: Electrical Diagram Pelgrim Combi

    MC4111L / MAG 690 Technische documentatie 13 - ELECTRICAL DIAGRAM PELGRIM COMBI...
  • Page 34: Electronic Card Pelgrim Combi

    MC4111L / MAG 690 Technische documentatie 14 - ELECTRONIC CARD PELGRIM COMBI ON THE OHMMETER Mark Component 30 Ω Ph - Gril Gril 32,5 Ω Ph – Convection grill Convection grill 60 Ω Ph - Fan motor Fan motor 192 Ω...
  • Page 35: Test Program Pelgrim Combi

    MC4111L / MAG 690 Technische documentatie 15 - TEST PROGRAM PELGRIM COMBI 15.1. - Important instructions • To place a container filled with water in the oven (for the tests in microwave modes). • To connect (if possible) an ammeter on the power supply of the oven.
  • Page 36 MC4111L / MAG 690 Technische documentatie Step Run and display Remarks • Buttons checking Button "START/STOP" checking NO ⇒ If connections to power card are OK, then button or display out of order. Continue the test Buttons checking • Button "TURNTABLE" checking NO ⇒...
  • Page 37 MC4111L / MAG 690 Technische documentatie Step Run and display Remarks Checking the damper • When the damper could be checked, the colon of the time is bilking. Only damper and cooling fan are on. Those stay on when door is opened...
  • Page 38: Electrical Diagram Atag Combi

    MC4111L / MAG 690 Technische documentatie 16 - ELECTRICAL DIAGRAM ATAG COMBI...
  • Page 39: Electronic Card Atag Combi

    MC4111L / MAG 690 Technische documentatie 17 - ELECTRONIC CARD ATAG COMBI ON THE OHMMETER Mark Component 30 Ω Ph - Gril Gril 32,5 Ω Ph – Convection grill Convection grill 60 Ω Ph - Fan motor Fan motor 192 Ω...
  • Page 40: Test Program Atag Combi

    MC4111L / MAG 690 Technische documentatie 18 - TEST PROGRAM ATAG COMBI 18.1. - Important instructions • To place a container filled with water in the oven (for the tests in microwave modes). • To connect (if possible) an ammeter on the power supply of the oven.
  • Page 41 MC4111L / MAG 690 Technische documentatie Step Run and display Remarks • Buttons checking Right switch board checking (+) NO ⇒ If connections to power card are OK, then Right switch board out of order. Continue the test • Right switch board checking (ENTER) Buttons checking NO ⇒...
  • Page 42: Controls On Power Card

    MC4111L / MAG 690 Technische documentatie 19 - CONTROLS ON POWER CARD Control: Ø Between X100 (L) and X101 (N) = 230 Volts. Between X100 and PAD100 (earth) = 230 Volts, if not, disconnect the oven and invert the pods on X100 and X101 to refer the neutral on the components low tension.
  • Page 43 Alle teksten en illustraties Copyright 2005 Michel Prinsen © ATAG ETNA PELGRIM Home products b.v Impact 54-6921 RZ Postbus 249 – 6920 AE Duiven Nederland Alle rechten voorbehouden...

This manual is also suitable for:

Ma4111l

Table of Contents