A-4
1
GROUND CONNECTION
The frame of the welder must be grounded. An earth
grounding lead must be connected to the grounding
terminal, marked on the input box floor with the symbol
(See Figure A.2 ). Refer to Technical Specifi-
cations page for proper ground wire size.
INSTALLATION
FIGURE A.1
RATING PLATE LOCATION
1. RATING PLATE
INPUT SUPPLY CONNECTIONS
Be sure the voltage, phase, and frequency of the input
power is the same as specified on the rating plate.
• Do not touch electrically hot parts.
IDEALARC CV-400
WARNING
ELECTRIC SHOCK can kill.
• Have a qualified electrician
install and service this equip-
ment.
• Turn the input power off at the
fuse box before working on this
equipment.
A-4