Safety Information - Pioneer CDJ-850 Service Manual

1

SAFETY INFORMATION

A
This service manual is intended for qualified service technicians ; it is not meant for the casual do-it-
yourselfer. Qualified technicians have the necessary test equipment and tools, and have been trained
to properly and safely repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may
void the warranty. If you are not qualified to perform the repair of this product properly and safely, you
should not risk trying to do so and refer the repair to a qualified service technician.
WARNING
This product may contain a chemical known to the State of California to cause cancer, or birth defects or other reproductive
B
harm.
CAUTION
This product is a class 1 laser product classified
C
under the Safety of laser products, IEC 60825-1:2007.
CLASS 1 LASER PRODUCT
D
IMPORTANT
THIS PIONEER APPARATUS CONTAINS
LASER OF CLASS 1.
SERVICING OPERATION OF THE APPARATUS
S H O U L D B E D O N E B Y A S P E C I A L LY
INSTRUCTED PERSON.
E
F
2
1
2
D58-5-2-2a_A1_En
Laser Pickup specifications and Laser characteristics
For CD
1. Laser Interlock Mechanism
2. When the cover is opened, close viewing of the objective lens
CDJ-850
2
3
Health & Safety Code Section 25249.6 - Proposition 65
Wave length (typ) : 790 nm
Operation output : 4 mW CW, Class 1
Maximum output : Class 1 (Under fault condition)
Additional Laser Caution
The position of the switch (S1702) for detecting loading
completion is detected by the system microprocessor, and the
design prevents laser diode oscillation when the switch is not in
LPS1 terminal side (when the mechanism is not clamped and
LPS1 signal is high level.)
Thus, the interlock will no longer function if the switch is
deliberately set to LPS1 terminal side.
( if LPS1 signal is low level ).
In the Service mode the interlock mechanism will not function.
Laser diode oscillation will continue, if pin 41 of TC94A15FG
(IC201) on the MAIN Assy is connected to GND, or else the
terminals of Q201 are shorted to each other (fault condition).
with the naked eye will cause exposure to a Class 1 laser beam.
3
4
4