Acura EL 2005 Owner's Manual page 160

WEATHER SEAL BULB
HOLD-DOWN WIRE
CONNECTOR
2. Remove the electrical connector
from the bulb by pulling the
connector straight back.
3. Remove the rubber weather seal
by pulling on the tab.
4. Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way, and remove the bulb.
5. Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
6. Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked ''TOP''.
7. Push the electrical connector onto
the new bulb. Make sure it is
connected securely.
Turn on the headlights to test the
new bulb.
8. (Driver's side)
Reinstall the power steering
reservoir.
Replacing Front Turn Signal
Light and Fog Light Bulbs
1. If you are changing the bulb on
the driver's side, start the engine,
turn the steering wheel all the way
to the left, and turn off the engine.
If you are changing the bulb on
the passenger's side, turn the
steering wheel to the right.
CONTINUED
Lights
157