Table of Contents
Advertisement
Recording to a cassette tape (continued)
GX-CD5100W
■ Recording from a CD
1
Press the ON/STAND-BY button to turn the power on.
2
Load a cassette into the TAPE 2 cassette compartment with
side A facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the CD (CD) button and load the desired disc.
4
Press the
one side or both sides.
5
Press the
Recording will be paused.
6
Press the
side B.
CD playback will start approximately 7 seconds after the tape
starts.
To perform programmed recording:
1 Programme discs and tracks. (See page 17.)
2 Press the
3 Press the
To stop recording:
Press the
The CD and tape will stop.
Note:
To record on both sides, begin with side A. (If recording is started
from side B, the tape will not switch over to side A.)
Caution:
Do not open the CD compartment during recording.
Auto restart function:
If the recording side is switched from side A to B during recording,
the system will record the interrupted track on side B from its begin-
ning. The recording will be made without cutting the beginning of the
track on side B.
22
Downloaded From Disc-Player.com Sharp Manuals
button to choose
... To record on both sides.
... To record on only one side.
button.
button to record on side A, or the
(TAPE-2
) button.
button to record on side A, or the
( ) button.
■ Recording from the radio
1
Tune in to the desired station. (See page 18.)
2
Load a cassette into the TAPE 2 cassette compartment
with the side A facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the
button to choose one side or both sides.
... To record on both sides.
...To record on only one side.
4
Press the
button.
Recording will be paused.
5
button for
Press the
button to record on side A, or the
the remote control for side B.
To record on both sides, begin with side A. (If recording is start-
ed from side B, the tape will not switch over to side A.)
To interrupt recording:
Press the
button.
To resume recording, press the same recording button you pressed
in step 5. Other buttons do not allow resuming.
button for side B.
To stop recording:
Press the
button.
Beat cancel switch:
If a whistling noise occurs when recording from an MW, SW1 or SW2
station, set the BEAT CANCEL switch to A, B or C, whichever gives
the best reception.
04/1/28
button on
CX-GD5100V_EN2.fm
Advertisement
Table of Contents
