Hazet 9212 N-1 Operating Instructions Manual page 18

4. Application
Fixation of the rechargeable battery:
• Push battery in until it locks into place with a
"clic"-sound.
• If the battery has not locked into place it can
loosen from the tool and fall down being damaged
or hitting other persons.
• The battery pack has a state of charge display.
The „+" button and 4-step LED's (green) indicate
remaining capacity status and over temperature
condition
• The green LEDs show the remaining capacity
and temperature protection status when the „+"
button is shortly pressed.
Capacity Indication
green leD
LED 1
LED 1, 2
LED 1, 2, 3
LED 1, 2, 3, 4
LED 1 blinking (0,25 sec)
LED 1, 2, 3, 4 blinking
(0,5 sec)
Detaching of the battery:
• Press safety-locking (blue) and pull battery from
the handle.
Always wear personal protective clothing and safety equipment!
18
Design and Function
3
status
0 - 25 %
26 - 50 %
51 - 75 %
76 - 100 %
Fully Depleted
Over Temperature
condition
Prior to operation:
• Clean up work area.
• Keep trespassers out of the work area.
• The work place should be well lit and ventilated.
• Make sure that the rechargeable battery is in-
serted correctly and has locked into place.
Adjusting the sense of rotation:
• The sense of rotation is adjusted with the inverse
button.
Attention
While the tool is in operation, the sense
of rotation cannot be changed. In or­
der to change the sense of rota tion,
the impact wrench has to be stopped
and then you can push the button for
changing the sense of rotation.
Operation
• Press trigger for tool operation.
• Release trigger to stop tool operation.
• With the operation trigger the speed/number of
revolutions can be adjusted continuously. Press
trigger slightly for low speed/number of revolu-
tions, press it stronger for high speed/number of
revolutions.
note:
• Loud operation noise!
• Wear ear protection!
tightening and loosening screws:
• For tightening and loosening screws, choose a
socket fitting the screw.
Attention
Avoid too long screw­tightening, the
screw may be tightened too much and
could break.
• When tightening screws with the impact wrench,
always hold it in a right angle to the screw.
• If the impact wrench is fitted at an angle, the
screw's head might be damaged and the force
will not be transmitted onto the screw.