Advertisement
• The digital outputs are clocked for the different digital inputs.
By switching over between inputs, there can be a synchronicity moment occur where by
the transport stays in the mute mode. In that situation, the CD360 can be reset by
switching off with the power switch for approximately 10 seconds and then again to on.
• The SPDif RCA and optical outputs are able to transmit digital stereo signals to
converters capable to receive, 16bit/44.1kHz when CD is playing (standard CD format).
When used as DAC, the digital outputs send through the signal and format of the input
which is switched on.
• All audio CD's, CD-R's and CD-RW's can be played without a problem only when they
are produced following the Red Book protocol.
• For your convenience you will find a red sticker, indicating the mains "phase". The phase
of your electricity system can be determined with a voltage seeker.
• The transport must only be cleaned with a cloth, impregnated with a Ph-neutral cleaning
fluid. And it must be mildly moist! NEVER use strong fluids and/or erasers. Before
cleaning ALWAYS remove the power cord from its wall socket, by its plug not by its cord.
• The optimum operating temperature is reached after approx. several hours of continuous
play. Then it will be possible to start enjoying the superb van Medevoort audio qualities of
this transport. Test this time in your own setup.
• We strongly recommend that you use a high quality interconnect cable. E.g. the
renowned van Medevoort Silver Cable. Also for the power cords.
• For other questions, please contact your dealer.
IMPORTANT
When seeking warranty service, it is the responsibility of the consumer to establish proof and
date of purchase. Your purchase receipt or invoice is adequate for such proof.
7
vM CD360 STEREO CD PLAYER / DAC
Controls
Precautions
Connections
Maintenance and advice
Technical Specifications
Advertisement
