Advertisement
• ONLY connect the player to a (professionally installed) wall socket with earth or ground
and the corresponding voltage setting, as indicated on the back. Any faulty connection
will invalidate the warranty.
• If it is necessary to replace the fuses, use only fuse(s) with the exact same value. The
fuse holders are positioned inside the transport and should only be replaced by an
authorized Van Medevoort Service Center. There are no user serviceable parts inside.
• The correct order for ON/OFF switching of the various products is as follows:
On: always first the source, then the pre-amplifier, followed by the power amplifier.
Off: always first the power amplifier, then the pre-amplifier, followed by the source.
• To prevent damage to your loudspeakers it is advisable, both at switching ON and OFF to
turn the volume control fully to the left. Fully anti-clockwise sets the volume at its lowest
level. The same applies when changing sources.
• Do make sure that there is enough space in front of the transport in order to change CD's
safely.
• Do not put any magnetic devices near or on top of the transport, e.g. floppy disks. This
can cause irreparable damage to such devices.
• If you experience any problems, always contact your nearest authorized Van Medevoort
dealer or distributor.
5
vM CD360 STEREO CD PLAYER / DAC
Controls
Precautions
Connections
Maintenance and advice
Technical Specifications
Advertisement
