Installing With Wires Only (No Terminals) - Alpine PXA-H900 Manual For Installation And Connections

Installing with wires only (no terminals)

The hexagonal screw must be used when installing with wires only (without terminals). We
strongly recommend having connections made by your store of purchase.
If you wish to make connections yourself, read the instructions below carefully and be sure to
connect properly.
• When making connections, be sure to use the included hexagonal screw and hexagonal
wrench.
• For safety, leave the power cord unplugged until all connections have been completed.
• Do not carry the PXA-H900 by its cord. The cord may be damaged and the PXA-H900 may
fall.
1. Check the thickness of the wires.
NOTES
• Use wires larger than the PXA-H900's fuse capacity.
• Wire sizes usable with the PXA-H900 are AWG8 to AWG10.
• If you do not know the thickness of the wires, contact your store of purchase, a service shop or/and Alpine service
center.
2. Strip 7 to 10mm (1/4" – 3/8") of the wire's insulation.
Cord
NOTES
• If the exposed section is too short, the current will not flow properly, resulting in the PXA-H900 not operating or breaks
in the sound.
• Making the exposed section too long may lead to short-circuit.
3. Pass the wire through the terminal board cover.
4. Remove the screw mounted on the PXA-H900. Insert the bare wire into the lead terminal and
fasten it with the hexagonal screw. Tighten the screw using the hexagonal wrench.
NOTE
Be sure that the cord is fully inside the lead terminal and that not a single wire of its core is sticking out. If even a single
wire is sticking out, this may lead to short-circuit with the vehicle's body or the PXA-H900, resulting in fire or malfunction.
5. Mount the terminal board cover on the PXA-H900.
18
-EN
7 to 10mm
(1/4" – 3/8")
Hexagon screw
Cord
To PXA-H900's lead terminal
Lead terminal