Advertisement
Owners Manual for TP4X, TP8X, TP12QX, and TP18SX
PRIOR TO USING THIS MACHINE, MAKE SURE THAT YOU HAVE READ, AND UNDERSTAND
THE SAFETY AND OPERATING INSTRUCTIONS FOR THIS MACHINE.
NaceCare Solutions
1205 Britannia Road East
Mississauga, Ontario, Canada
L4W 1C7
Toll Free: 1 800 387 3210
Toll Free Fax: 1 800 709 2896
Advertisement
Table of Contents
Related Manuals for Nacecare TP4X
Summary of Contents for Nacecare TP4X
- Page 1 Owners Manual for TP4X, TP8X, TP12QX, and TP18SX PRIOR TO USING THIS MACHINE, MAKE SURE THAT YOU HAVE READ, AND UNDERSTAND THE SAFETY AND OPERATING INSTRUCTIONS FOR THIS MACHINE. NaceCare Solutions 1205 Britannia Road East Mississauga, Ontario, Canada L4W 1C7...
- Page 2 Safety instructions (read carefully) Every electrical device must be used for its particular function only, respecting the manufacturer’s instructions. Failure to adhere to these instructions could result in serious bodily injury to the operator (shock, electrocution, etc.). Please read the following safety instructions carefully and ensure that you understand them prior to using the machine.
- Page 3 SETUP 1. Remove the 2 spring clips holding the upper tank to the lower tank (TP4X, and TP8X only) 2. Fill the solution tank with cold or warm water through the filling hole. Add non-foaming chemical to the solution tank, diluting it according to the manufacturers specifications.
- Page 4 2. Connect the vacuum hose to the machine as shown in Fig 1 (TP12QX and TP18SX have the connections in the rear of the machine). 3. Connect the solution hose to the machine as shown in Fig 2 4. Connect the wand/hand tool to the end of the hose as shown in Fig 3 Fig 1 Fig 2 Fig 3...
- Page 5 4. Periodically check and clean the filter for the vacuum motor. It is located between the 2 tanks for the models TP4X and TP8X and below the recovery dome for the TP12QX and TP18SX. 5. After 500 working hours, the machine should be brought in to be serviced. The carbon brushes on the vacuum motor and pump motor should be replaced at this time.
Need help?
Do you have a question about the TP4X and is the answer not in the manual?
Questions and answers