Erasing Homelink Buttons; Reprogramming A Single Homelink Button; Positive Retention Floor Mat - Lincoln 2011 MKX Owner's Manual

Erasing HomeLink buttons

To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink is now in the train (or learning) mode and can be
programmed at any time beginning with Step 1 in the Programming
section.

Reprogramming a single HomeLink button

To program a device to HomeLink using a HomeLink button previously
trained, follow these steps:
1. Press and hold the desired HomeLink button. Do NOT release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink button, follow Step 1 in the Programming
section.
For questions or comments, contact HomeLink at www.homelink.com
or 1–800–355–3515.

POSITIVE RETENTION FLOOR MAT

WARNING: Do not install additional floor mats on top of the
factory installed floor mats as they may interfere with the
accelerator or the brake pedals.
2011 MKX (mkx)
Owners Guide, 1st Printing
USA (fus)
Driver Controls
83