Pintek PA-655 Instruction Manual page 17

Table 6: Certifications and compliances
EC Declaration
of
Conformity –
Low Voltage
Additional
Compliance
Compliance was demonstrated to the following
specification as listed in the Official Journal of the
European Union:
Low Voltage Directive 73/23/EEC, as amended by
93/68/EEC
EN 61010-1/A2:1995
Safety requirements for electrical equipment for
measurement, control, and laboratory use.
EN 61010-2-032:1995
Particular requirements for hand-held current clamps
for electrical measurement and test equipment.
IEC61010-1/A2:1995
Safety requirements for electrical equipment for
measurement, control, and laboratory use.
IEC61010-2-032:1994
Particular requirements for hand-held current clamps
for electrical measurement and test equipment.
www.tmatlantic.com
17
Figure 9:
Phase versus
frequency at 1 A
peak, typical