Table of Contents
Advertisement
How to extend the power wiring
Items to prepare
Tools
Crimping pliers
Spec
Shape
1. As shown in the figure, peel off the shields from the rubber/wire
of the power cable.
- Peel off 20 mm of the wire shields of the tube installed already.
2. Insert both sides of core wire of the power cable into the connection sleeve.
3. Using a compressor, compress the two points and flip it over
and compress another two points in the same location.
- The compression dimension should be 8.0.
- After compressing it, pull both sides of the wire to
make sure it is firmly pressed.
4. Wrap it with the insulation tape twice and position your
contraction tube in the middle of the insulation tape.
5. Apply heat to the contraction tube to contract it.
6. After tube contraction work is completed, wrap it with the
insulation tape to finish.
Insulation tape
English-18
20
0.79(20) 0.79(20)
20
20
0.79(20)
60
2.36(60)
4.72(120)
120
180
7.09(180)
0.79(20)
20
Comp. dim.
Compress it 4 times
Insulation tape
Contraction tube
Insulation tape
Advertisement
Table of Contents
