Sony TRINITRON KV-32HS20 Service Manual page 276

Cable and Antenna
Cable Box
Connections
If your cable provider does not feature local channels, you may find
this set-up convenient.
CATV cable
(No connection to
TO CONVERTER)
Antenna cable
Select CABLE or antenna (ANT) mode by pressing ANT on the remote
control.
To receive channels using an antenna, instead of the CATV cable:
1
Select antenna mode by pressing ANT on the remote control.
2
Turn the cable to OFF (see page 40).
3
Perform the Auto Program function (see page 40).
Cable Box and Cable
This is the preferred basic cable TV hookup to use if your cable TV
company scrambles some channels, but not all of them (pay channels
vs. regular cable channels), so you need to use a cable box.
With this setup you can:
Use the TV remote control to change channels using your cable
box when the signal is scrambled.
Use the TV remote control to change channels using your TV
when the signal is not scrambled. (Your TV's tuner provides a
better signal than the cable box.)
Use the Twin View feature. (When all channels are routed
through your cable box, only one signal is sent to the TV, so you
can not use the Twin View feature.)
Use the Twin View feature normally with the CATV input.
Use the Twin View feature partially with the cable box. When you
switch the TV input to AUX — to use the cable box — the
unscrambled picture from the cable box will display. You can
display the signal from both AUX and VHF/UHF inputs in the
left Twin View picture, but you can display only the signal from
the VHF/UHF input in the right Twin View picture.
AUX
Rear of TV
TO CONVERTER
VHF/UHF
Installing the TV
11